Aflati pretul pentru JUMO 603070/0020-5-384-000-70-0-00-80

JUMO 60003390

Thanks to its impact-resistant housing made of high-quality plastic, the 1-pole mechanical body thermostat with changeover contact is very robust and can also be used under harsh conditions. The measuring system used works on the principle of liquid expansion and can be used up to a maximum permissible sensor temperature of 600 ° C without any problems. The maximum permissible ambient temperature on the housing (protection class IP54) is 80 ° C. The housing is attached directly to the lower part of the housing by means of a sheet metal flange with two screws, hole spacing 65 mm. With the help of a screwdriver, the desired switch-off temperature can be easily set on a scale after removing the housing cover. The set switch-off temperature can be viewed at any time through a viewing window in the housing cover. The safety temperature monitor is characterized by a high switching point accuracy of + 0 / -5 K in the upper half of the scale. The built-in temperature compensation reduces ambient temperature influences on the switch head to a minimum. A decisive advantage is that no additional auxiliary energy is required for temperature measurement. The electrical connection is made using PushIn © terminals, which significantly reduces installation time compared to conventional screw connections. The maximum permissible switching capacity is AC 230 volts / 16 A. The thermostat has a switching difference (hysteresis) of approx. 35 K and automatically switches back to its original state when the switch-off temperature falls below this value. When the temperature at the sensor cools below -20 ° C, the circuit between terminals 1 and 2 opens, but closes again automatically when the temperature rises. If the measuring system is destroyed, the circuit is opened permanently, the switch contact is then in a neutral position. The safety temperature monitor can be used very flexibly and is used both in building automation and in heating, air conditioning and ventilation technology. Other areas of application are the plastics industry, apparatus and machine construction, furnace construction and temperature monitoring in laboratory and climatic cabinets. The device is approved according to DIN EN 14597 and PED and has an EAC approval.